New Functions in 02R96 Version 2
7
02R96 Version 2—Owner’s Manual
Aux Sends
•
You can exclude channels from Aux Sends (Mix Minus).
→
•
You can copy the channel fader positions to Aux Sends.
→
•
You can set all Send levels to nominal simultaneously.
→
•
If an Aux Send is set to pre-fader, you can set the Pre point before or after the [ON] button.
→
Common Channel Functions
•
Input and Output Channel Meter pages indicate the gain reduction being applied by the
Gate and Compressor.
→
•
You can select whether the Input Channel’s Pan setting is used when the Input Channel Solo
signal is set to Pre Fader.
→
•
Raising the channel faders for soloed Channels from –
∞
can unsolo the Channels.
→
•
The AUX SELECT [AUX 1]–[AUX 8] buttons enable you to solo or unsolo Aux Sends.
→
•
The Fader Group Master function enables you to control the overall level of the Fader group
channels simultaneously while maintaining the relative level balance of each channel.
→
•
The Mute Group Master function enables you to mute all channels in a Mute group simul-
taneously.
→
Monitor
•
The level of the Surround Monitor can be reset to 85dB SPL.
→
•
A new parameter has been added to Base Management on the Surround Monitor Setup
page.
→
•
Surround Monitor is also available when Surround mode is set to Stereo.
•
You can simultaneously select BUS and SLOT on the Surround Monitor page.
•
You can select from Slot Channel 9 through Channel 16 as Surround Monitor signal sources.
•
You can simultaneously select 2TRD, D2, D3, A1, or A2, and STEREO, ASSIGN1, or
ASSIGN2 as Control Monitor signal sources.
•
You can select the Talkback mic signal as the Studio Monitor source.
→
Internal Effects and Plug-ins
•
You can add optional Add-On Effects to the preset effects.
→
Scene Memory
•
You can globally apply the Fade Time setting to all scenes.
→
•
You can globally apply the Recall Safe setting to all scenes.
→
•
Any channel or parameter settings in the current scene can be copied and pasted into other
scenes.
→
•
You can select more parameters for the Recall Safe function.
→
Automix
•
You can insert the current mix parameters in a region specified in the Automix data.
→
•
Touching the faders can punch parameter values in and out if the corresponding OVER-
WRITE button is set to on.
→
•
A parameter related to timecode synchronization has been added.
→