Yaesu VR-160, Operating Manual, Page: 85 / 100

VR-160 O
PERATING
M
ANUAL
83
Set Mode Item 41
[
RX MODE
]
Function
: Selects the Receiving mode.
Available Values : N-FM/AM/W-FM/AUTO
Default
: AUTO (Mode automatically changes according to operating frequency.)
Note : This Set Mode Item can select and set the function to each memory channel indi-
vidually.
Set Mode Item 42
[
RX SAVE
]
Function : Selects the Receive-mode Battery Saver interval (“sleep” ratio)
Available Values
: 200ms - 900ms (100 ms/step), 1.0sec - 10.0sec (0.5 sec/step), or OFF
Default : 200 mS (1:1)
Set Mode Item 43
[
SCAN LAMP
]
Function
: Enables/Disables the Scan lamp (while scanner is paused).
Available Values : OFF/ON
Default
: ON
Set Mode Item 44
[
SCAN RE-START
]
Function : Select the Scan Re-start Delay time.
Available Values
: 100ms - 900ms (100 ms/step), 1.0sec - 10.0sec (0.5 sec/step)
Default : 2.0sec
Set Mode Item 45
[
SCAN RESUME
]
Function
: Selects the Scan Resume mode.
Available Values : 2.0sec - 10.0sec/BUSY/HOLD
Default
: 5.0sec
2.0sec - 10.0sec: The scanner will halt on a signal it encounters, and will hold there for the
selected resume time. If you do not take action to disable the scanner
within that time period, the scanner will resume even if the station is still
active.
BUSY: The scanner will halt on a signal it encounters. When the signal drops,
the scanner will resume. The Scan resume time (default 2 seconds) is set
by the Set Mode Item 44:
SCAN RE-START .
HOLD: The scanner will halt on a signal it encounters. It will not restart auto-
matically; you must manually re-initiate scanning if you wish to resume.
S
ET
(
M
ENU
)
M
ODE