Yaesu VR-160, Operating Manual, Page: 73 / 100

VR-160 O
PERATING
M
ANUAL
71
S
ET
(
M
ENU
)
M
ODE
The VR-160 Set Mode, already partially discussed in many previous chapters, is easy to
activate and set. The Set Mode is used to configure a wide variety of radio parameters,
some of which have not been detailed previously. Use the following procedure to activate
the Set Mode and adjust the various parameters:
1. Press and hold in the [ BANK
] key for one second to enter the
Set mode.
2. Rotate the DIAL knob to select the Set Mode Item to be adjusted.
Note : Do not forget to pull the
DIAL
knob to rotate the
DIAL
knob.
3. Press the [ BANK
] key briefly to enable adjustment of the Set
Mode Item.
4. Rotate the DIAL knob to adjust or select the parameter to be
changed on the Set Mode Item selected in above step.
5. After completing your selection and adjustment, press and hold in the [ BANK
] key for
one second to save the new setting and exit to normal operation.
M
ASKING THE
S
ET
M
ODE
I
TEMS
There may be situations where you want to “Mask” Set Mode Items so they are not re-
called during Set Mode Item selection.
1. Press and hold in the [ BANK
] key for one second to enter the Set mode.
2. Rotate the
DIAL
knob to select the Set Mode Item 25: EXTENDED
MENU
.
Note : Do not forget to pull the
DIAL
knob to rotate the
DIAL
knob.
3. Press the [ BANK
] key briefly to enable adjustment of the Set
Mode Item.
4. Rotate the DIAL knob to select “
ON
”, then press the [ BANK
]
key briefly.
5. Rotate the DIAL knob to select the Set Mode Item to be
“Masked”.
6. Press the [ F/W
] key briefly. A small “
” icon will appear betwenn
the “Set Mode Item Number” and “Set Mode Item Name”, indi-
cating the Set Mode Item is to be Masked.
7. Rotate the
DIAL
knob; the previously-selected Set Mode Item will be “Masked”.
8. Repeat steps 5 - 7 above, to append the “ ” icon to any other Set Mode Item you wish
to “Masked”.
9. Press and hold in the [ BANK
] key for one second to save the new setting and exit to
normal operation.
To unmask the hidden Set Mode Item, repeat the above procedure. In step 4 above select
“
OFF
” and in step 6 above the “ ” icon will disappear from the Set Mode Item you wish to
unmask.