Yaesu FT-2000D, Operating Manual

Page: 124 / 140

Page 122 FT-2000D O
PERATING
M
ANUAL
063 A1A FRQDISP
Function : Selects the frequency Display Format for the
CW mode.
Available Values : dir / OFSt
Default Setting : OFSt
dir (Direct Frequency): Displays the receiver carrier
frequency, without any offset
added. When changing
modes between SSB and CW,
the frequency display re-
mains constant.
OFSt (Pitch Offset): This frequency display re-
flects the added BFO offset.
064 A1A PC KYNG
Function : Enables/disables CW keying from the
“PACKET PTT” terminal (pin 3) on the rear panel’s
PACKET jack while operating on the CW mode.
Available Values : EnA (Enable) / diS (Disable)
Default Setting : diS (Disable)
065 A1A QSKTIME
Function : Selects the time delay between when the
PTT
is keyed and the carrier is transmitted during QSK opera-
tion when using the internal keyer.
Available Values : 15 / 20 / 25 / 30 msec
Default Setting : 15 msec
MODE-DAT G
ROUP
066 dAtA DATA IN
Function : Selects the data input path to be used on the
PKT mode.
Available Values : dAtA / PC
Default Setting : dAtA
dAtA:Uses the data input line connected to pin 1 of
the
PACKET
jack while using the PKT mode.
PC: This parameter is for future expansion of this
transceiver’s capabilities, but at this time is not
supported.
067 dAtA DT GAIN
Function : Sets the data input level from the TNC to the
AFSK modulator.
Available Values : 0 ~ 100
Default Setting : 50
068 dAtA DT OUT
Function : Selects the receiver to be connected to the data
output port (pin 4) of the PACKET jack.
Available Values : nAin (Main) / Sub
Default Setting : nAin (Main)
069 dAtA OUT LVL
Function : Sets the AFSK data output level at the output
port (pin 4) of the PACKET jack.
Available Values : 0 ~ 100
Default Setting : 50
070 dAtA VOX DLY
Function : Adjusts the “VOX” delay (receiver recovery)
time on the PKT mode.
Available Values : 30 ~ 3000 msec
Default Setting : 300 msec
071 dAtA V GAIN
Function : Adjusts the “VOX” gain on the PKT mode.
Available Values : 0 ~ 100
Default Setting : 50
072 dAtA PKTDISP
Function : Sets the packet frequency display offset.
Available : –3000 ~ +3000 Hz (10 Hz/step)
Default : 0 Hz
073 dAtA PKT SFT
Function : Sets the carrier point during the SSB packet
operation.
Available : –3000 ~ +3000 Hz (10 Hz/step)
Default : 1000 Hz (typical center frequency for PSK31,
etc.)
MODE-CW G
ROUP
M
ENU
M
ODE