Yaesu FT-2000D, Operating Manual

Page: 136 / 140

Page 134 FT-2000D O
PERATING
M
ANUAL
I
NSTALLATION OF THE
O
PTIONAL
F
ILTER (YF-122C
OR
YF-122CN)
1. Turn the FT-2000D ’s [ POWER
] switch “off,” then
turn the
FP-2000
’s [
POWER
] switch “off.”
2. Unplug the AC cable from the
AC
jack on the
FP-
2000
rear panel.
3. Disconnect the all of the cables from the transceiver.
4. Referring to Figure 1, remove the three screws from
each side of the transceiver, and three screws from the
top edge of the rear panel. Slide the top cover toward
to the rear about 1/2 inch (1 cm), then remove the top
cover.
5. Refer to Figure 2 for the mounting location for the
optional filter. Position the filter so that its connectors
are aligned with the mounting pins on the board, and
push it into place.
6. Replace the top cover and its nine screws.
7. Filter installation is now complete. Now you must en-
able the newly-installed filter, using the Menu.
8. Connect the two DC cables to the FT-2000D rear panel,
and then connect the AC cable to the AC jack on the
FP-2000 rear panel.
9. Turn the
FP-2000
’s [
POWER
] switch “on,” then turn
the FT-2000D ’s [ POWER
] switch “on.”
10. Press the [ MENU
] button momentarily to engage the
Menu mode.
11. Rotate the Main Tuning Dial knob to select the Menu
item “
037 GEnE SUB FIL 037 GEnE SUB FIL
037 GEnE SUB FIL 037 GEnE SUB FIL 037 GEnE SUB FIL
.”
12. Rotate the [
SUB VFO-B
] knob to choose the selec-
tion appropriate for the filter you have just installed
(“
300 300
300 300 300
” for YF-122CN , “
500 500
500 500 500
” for YF-122C ).
13. Press and hold in the [
MENU
] button for two seconds
to save the new setting and exit to normal operation.
F
IGURE
1
F
IGURE
2
RX-2 UNIT
Optional Filter
RX-2 UNIT