Installation and Setup
WebRelay-10 Users Manual
2.4.2 Network Tab
The network parameters are set on this page.
Note: WebRelay-10 must be power-cycled (power disconnected, then reconnected) before network
settings take effect. Only the settings on the
Network
tab require power-cycling before taking effect.
Use DHCP (WebRelay-10 Plus™ only)
This option allows DHCP to be enabled or disabled. If this option is set to
Yes
, WebRelay-10 Plus™
will wait for an IP address from a DHCP server each time it is powered. The default setting is
No
(this is recommended for most installations). If DHCP is set to
Yes
, the Network page must be
submitted and WebRelay-10 Plus™ must be rebooted before an IP address will be assigned. Once
WebRelay-10 Plus™ is assigned an IP address by the DHCP, the new IP address can be found
through the clients list kept by the DHCP server. For most instances, this is found on the local
gateway or router.
page 22
Xytronix Research & Design, Inc.
Figure 2.4b - Network Tab
