Installation and Setup
WebRelay-10 Users Manual
WebRelay-10 can be used on a wireless network by connecting through an Ethernet bridge or a wireless
router. WebRelay-10 is connected directly to the wireless device.
Note: The wireless Ethernet bridge or router must be properly configured for the wireless network. Refer
to the installation instructions for the wireless device.Terminal Connector (WebRelay-10 Plus™ only)
The removable 5-position terminal connector is used for connecting temperature sensors, humidity
sensors, or discrete inputs. The terminals are described in the table below.
IMPORTANT: MAKE SURE WIRES ARE PROPERLY ATTACHED TO THE TERMINALS AND THAT
THE SCREW TERMINALS ARE TIGHT!
5-pin connector pinout
Pin
Description
Data
Temperature/Humidity Data. This is the data line
connection for the digital temperature/humidity sensors.
+5V Out
This output voltage is used to provide power for the digital
temperature/humidity sensors.
Ground
Ground connection for 5VDC output, and Inputs.
Input 1 & 2
Discrete Inputs.
page 12
Xytronix Research & Design, Inc.
Figure 2.2a - Network Connection
Figure 2.2b - Wireless Connection
