Installation and Setup
WebRelay-10 Users Manual
Server Name/IP Address
Specify the name or IP address of the Remote Services server here. If the IP address is specified,
enter it in this format aaa.bbb.ccc.ddd. For numbers that are less than 100, preceding zeros should
not be included (for example, enter 80 rather than 080). This field can be up to 40 characters long
and has no default setting.
Server Port
Enter the TCP port used for the Remote Services server. This can be set within the range of 0-
65535. The default setting for this field is 8000.
Connection String
This text is sent to the Remote Services server when the connection is established. This string
should include any information required by the server at connection. For example, it may include an
ID number, customer number, password, etc. The format is entirely dependent upon the server
requirements. This field can be up to 80 characters long. Default text is provided only as an example
placeholder. The default text is [<
serialAddress
>]:ControlByWeb,X-10.
Connection Interval
This field specifies the periodic interval in which WebRelay-10 attempts to connect to the remote
server, or if WebRelay-10 is already connected, it is the interval in which WebRelay-10 sends the
connection string. This field can be set within the range of 1 to 34452 minutes. The default setting
for this field is 1 minute.
SNMP Enabled
When this option is set to
Yes
, WebRelay-10 will support SNMP. The default setting for this option is
No
. (
See 2.4.3.2 SNMP
for more information.)
SNMP Manager IP
When SNMP is used, this field is used to specify the IP address of the SNMP manager. The default
setting for this field is 192.168.1.25.
SNMP Port
When SNMP is used, this field is used to specify the SNMP port that WebRelay-10 listens on. The
default setting for this field is 161.
SNMP Trap Port
When SNMP is used, this field is used to specify the SNMP Trap port of the SNMP manager. The
default setting for this field is 162.
IP Filter Range 1 and IP Filter Range 2
For additional security, WebRelay-10 has a simple built-in firewall. If desired, WebRelay-10 can be
configured to only allow access to client devices (computers, servers, other ControlByWeb™
devices, etc) with certain IP addresses. Two IP address ranges are provided and only client devices
with addresses that fall within those two ranges will be allowed access. Devices with IP addresses
that fall outside of those ranges will not receive any response from WebRelay-10. The following are
examples.
To allow access from any device (this is the default setting):
IP Filter Range 1:
0.0.0.0
255.255.255.255
IP Filter Range 2:
0.0.0.0
0.0.0.0
To limit access to only one device (address 192.168.1.33):
IP Filter Range 1:
192.168.1.33
192.168.1.33
IP Filter Range 2:
0.0.0.0
0.0.0.
To limit access to only devices on the local network and one device on the internet (address
10.143.100.32):
page 26
Xytronix Research & Design, Inc.
