Configuration Menu
9.
The MAXserver 1600 prompts:
Total installed memory in megabytes (1,3,5) [1]:
The prompt indicates the amount of installed memory for which the MAXserver has been configured.
If you remove memory, you must change this value. (Preferably, you should change this value before
you remove the memory.) Also, if you have enabled more software features than the MAXserver 1600
can support with the reduced memory, you will not be able to re-initialize the unit after you remove
the SIMMs. If this happens, you must re-install the SIMMs and configure the TCP/IP-LAT software
image for fewer features.
SIMMs should only be installed or removed by qualified personnel. SIMM Installation Service
Instructions, which explain how to install and renove SIMM memory modules, are available from
Xyplex
1
.
The MAXserver 1600 automatically detects added memory. Therefore, you do not need to increase
the "installed memory" value when you install additional memory. If you choose to increase the value
anyway, do not do so before you install the additional memory. If you do, the MAXserver 1600 will
generate the following warning message:
WARNING: After saving the new configuration, you must turn the
unit off and install the additional memory specified (x MB).
(This message appears only while you are using the Configuration menu.)
In addition, you will be prompted to turn off the unit and install the memory if you attempt to exit the
Configuration menu, saving changes (Option S). Also, the front panel lights will flash an error code
the next time the MAXserver 1600 is initialized, if you have not yet installed the memory.
10. The MAXserver 1600 prompts:
(Type any key to continue)
Press any key; the MAXserver 1600 returns you to the Configuration menu.
1
The order code for for a 2 MByte SIMM memory upgrade kit is MX-500-5744. If you only need Service
Instructions, the part number is MX-420-0608.
0590
41
