Configuration Menu
4.3.1
Option 1 - Display Configuration
To select this option, answer 1 to the "Enter menu selection" prompt. The display shows a list of currently
stored configuration values and the new configuration values, similar to the list shown in Figure 4-2:
Configuration Stored Configuration New
Parameter load method: XMOP MOP XMOP MOP
Image load method: CARD DTFTP MOP CARD DTFTP MOP
Dump method: XMOP MOP BOOTP RARP XMOP MOP BOOTP RARP
XMOP/MOP filename: PROFILE.SYS PROFILE.SYS
Default unit IP addr: 173.179.90.21 173.179.90.21
DTFTP host IP addr: 173.179.90.4 173.179.90.4
DTFTP gateway IP addr: 0.0.0.0 0.0.0.0
DTFTP filename: mx1600.sys mx1600.sys
Load status messages: Disabled Disabled
Network interface: Thinwire Thinwire
Memory size expected: 2 Megabytes 2 Megabytes
(Found 2 Megabytes)
(Type any key to continue)
Figure 4-2. Sample Unit Configuration Display
The DTFTP (Directed Trivial File Transfer Protocol) information is present when DTFTP is listed as
an Image load method. Similarly, the XMOP/MOP load filename is present when XMOP or MOP is
listed as an Image load method.
4.3.2
Option 2 - Modify Unit Configuration
To select this option, answer 2 to the "Enter menu selection" prompt. The MAXserver 1600 prompts:
Initialize configuration to defaults (Y,N) [N]?
Valid answers to this prompt are Y (Yes) and N (No).
•
If you answer ‘Y’, the MAXserver 1600 returns all configuration options to their factory default
values,
which are:
Parameter load method:
NVS
Image load method:
CARD, XMOP, MOP, BOOTP, RARP
Dump Method:
XMOP, MOP, BOOTP, RARP
XMOP/MOP load filename:
MX1500
Default unit IP address:
0.0.0.0
Total installed memory:
1 Megabyte
Load status messages:
Enabled
Network interface:
Auto
36
0590
