Chapter Three - Installation
33
Xycom Controller
Note
For VNHS with the AHIP6 board: If touch-
screen is factory installed, the touchscreen is set
up on the AUX port, making this port unavail-
able.
If you want to reconfigure the touchscreen to use the COM2
port, perform the following steps:
1.
Disconnect the power.
2.
Remove the lid.
3.
Remove the touchscreen controller card (see Figure 3-18B)
.
1
39
40
A B
J1
J2
J3
J4
J5
TOUCH SCREEN
CONTROL CONN.
JUMPERS
J7
J8
J9
2
Figure 3-18B. Touchscreen controller card
4.
Reconfigure jumpers J1-J9. Position A = COM2. Position B
= PS/2 AUX. (Note: all jumpers must be in the A or B po-
sition).
5.
Reinstall the touchscreen controller card.
6.
Reboot the computer.
7.
Using the touchscreen manual, do the following:
•
Uninstall the UPDD Touch driver.
•
Locate the Touch-Base Serial mode driver on the Xy-
com DOC CD.
•
Follow the instructions on the readme.txt file for the se-
rial mode UPDD driver.
8.
Replace the lid.