3500 Series Flat Panel Industrial PC
2
Revision
Description
Date
A
Manual Released
4/99
B
Added 3515KPM
1/00
C
Updated Bulb Replacement Instructions
11/00
D
Touchscreen Updates
7/02
Trademark Information
Brand or product names are registered trademarks of their respective owners.
Windows is a registered trademark of Microsoft Corp. in the United States and other countries.
Copyright Information
This document is copyrighted by Xycom Automation Incorporated (Xycom Automation) and shall not be reproduced or copied without ex-
pressed written authorization from Xycom Automation.
The information contained within this document is subject to change without notice. Xycom Automation does not guarantee the accuracy of the
information and makes no commitment toward keeping it up to date.
United States FCC Part 15, Subpart B, Class A EMI Compliance Statement:
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial envi-
ronment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense.
For European Users:
WARNING
This is a Class A product. In a domestic environment this product may cause radio interference in which case the user may be required to take
adequate measures.
INSTALLATION: Electromagnetic Compatibility WARNING
The connection of non-shielded equipment interface cables to this equipment will invalidate FCC EMI and European Union EMC compliance
and may result in electromagnetic interference and/or susceptibility levels which are in violation of regulations which apply to the legal operation
of this device. It is the responsibility of the system integrator and/or user to apply the following directions which relate to installation and con-
figuration:
1.
All interface cables must include shielded cables. Braid/foil type shields are recommended. Communication cable connectors must be
metal, ideally zinc die-cast backshell types, and provide 360 degree protection about the interface wires. The cable shield braid must be
terminated directly to the metal connector shell, ground drain wires alone are not adequate.
2.
For systems other than Pentium II logic board (AHIP6+): In those cases where an external mouse is used, the snap-on ferrite bead provided
(P/N 116046) must be installed on the mouse cable at the host end in order to comply with relevant EMI regulations.
3.
Protective measures for power and interface cables as described within this manual must be applied. Do not leave cables connected to
unused interfaces or disconnected at one end. Changes or modifications to this device not expressly approved by the manufacturer could
void the user’s authority to operate the equipment.
4.
EMC compliance is, in part, a function of PCB design. Third party add-on AT/XT peripheral PCB assemblies installed within this appara-
tus may void EMC compliance. FCC/CE compliant PCB assemblies should always be used where possible. XYCOM AUTOMATION can
accept no responsibility for the EMC performance of this apparatus after system integrator/user installation of PCB assemblies not manu-
factured and/or expressly tested and approved for compliance by XYCOM AUTOMATION. It is the responsibility of the system integra-
tor/user to ensure that installation and operation of such devices does not void EMC compliance.
Xycom Automation
Technical Publications Department
750 North Maple Road
Saline, MI 48176–1292
734-429-4971 (phone)
734-429-1010 (fax)