3500 Series Flat Panel Industrial PC
20
Feature
Description
Power Receptacle
The AC power receptacle is a three-pin connector on the left side of
the unit; the DC power supply uses a terminal block.
Monitor Auxiliary Power Outlet
The outlet is intended for use only in testing situations, outside haz-
ardous locations, and is covered by a retainer bracket for safety rea-
sons.
Note
: A flat panel display and a CRT cannot be used simulta-
neously on a display. Simultaneous video is only available on TFT
systems with the “Simultaneous Video” utility program, or configured
in the BIOS setup menus..
Retainer Bracket (AC) or P-
Clamp (DC)
With an AC power supply, this bracket can be screwed into the two
studs, as shown in 3-21, to retain the power connector and to cover
the Monitor Auxiliary outlet. If an optional DC power supply is installed,
use the P-Clamp to provide power cord strain relief.
Warning: Absence of this bracket may result in a disengaged
power connector. If this occurs, an explosion may result in a
hazardous environment.
Fan and Filter
The fan and filter, located on the left side panel, are cooling system
components. The filter is replaceable and can be removed for cleaning.
Exhaust Fan
The exhaust fan is a cooling system component.
Vent Filter
The vent and filter is a cooling system component to allow air to circulate.
Installation Options
This section describes how to install internal and external hardware options.
Internal Hardware Options
Caution
Turn off the unit and remove power before installing internal hardware.
To install internal hardware options unlatch and remove the lid.
SDRAM and Additional SDRAM Dual In-Line Memory Modules
(DIMMs)
You can order your unit CPU factory-configured for many configurations of SDRAM.
You can reconfigure the SDRAM capacity by changing the SDRAM DIMMs on your
board. For more information, refer to the CPU manual.
PC/AT or PCI Boards
1.
Check that the memory and I/O configuration of the board you want to install do not
conflict with the CPU and I/O memory maps in your CPU board manual.
2.
Using the two latches, remove the lid.
3.
Remove the ORB screw and blank ORB from the desired track.