3500 Series Flat Panel Industrial PC
30
Touchscreen Drivers
Depending upon the date of purchase, the Xycom Automation unit will have one of two
possible touchscreen controllers:
•
The Microtouch Controller P/N 114084
•
The Xycom Controller
P/N 140554
These controllers function similarly. However, the following sections require attention to
the type of controller installed.
Microtouch Controller
If the touchscreen is factory-installed, you will receive a disk with MS-
DOS and Windows 95 touchscreen drivers. If Windows 95 or Windows
NT is factory-installed, the touchscreen drivers are provided. If you
change the operating system, you must install the corresponding touch-
screen driver software. Refer to the touchscreen manual for instructions.
Note
If the Windows or Windows NT operat-
ing system is factory installed, then
touchscreen is set up on COM2, making
this port unavailable.
Xycom Controller
If the touchscreen is factory-installed, you will receive a CD with MS-
DOS and Windows touchscreen drivers. If Windows is factory-installed,
the touchscreen drivers are provided. If you change the operating system,
you must install the corresponding touchscreen driver software. Refer to
the touchscreen manual for instructions.
CD-ROM Drivers
A CD-ROM driver disk comes with the CD-ROM option, as well as the preinstalled
driver for the operating system you have selected. If you change operating systems and
need help loading the required CD-ROM driver, contact Xycom Automation technical
support at 1-800-289-9266 x450.
Note
If you need to reinstall Windows NT, you must have an internal CD-
ROM drive or an external parallel port CD-ROM drive as Windows NT
only
ships on a CD-ROM disk.