
MX Series — MX24 Operating Instructions
Page 13
ta
x
Operating Your MX24: Initial Set-up and Switching On
Please read all documentation before operating your unit and retain all documentation for
future reference.
Do not spill water or other liquids into or on the unit and do not operate your unit while
standing in liquid.
Do not block ventilation outlets or operate the unit in an environment that could impede the
free flow of air around the unit.
If your unit is used in an extremely dusty or smoky environment, it should be cleaned of any
collected debris at regular intervals. Please also see the notes regarding maintenance on
page 32.
Switching On…
The previous settings of all controls will be recalled, and the audio will fade up after initial
boot-up. Note that if the outputs are being fed from a Dante source (MX24-D), this will take
longer to reconnect than analogue and AES sources and may start suddenly (after the output
fade).
A note about the analogue controls
As these are normal potentiometers and not rotary encoders, their physical position
determines their setting. As it’s entirely possible they may have been adjusted when the unit
is powered down, be aware that their new position will be used when next powered up, so
please check the gains and headphones level before engaging!