11
Item
Description
◆
When the pulley is installed on the servo motor shaft with keyway, the
screw hole is used at the end of the shaft. In order to install the pulley, the
double-headed nails are inserted into the screw holes of the shaft, the washer is
used on the surface of the coupling end, and the pulley is gradually locked with
the nut.
◆
For the servo motor shaft with keyway, use the screw hole at the end of the
shaft to install. For shaft without keyway, friction coupling or similar methods
are used.
◆
When the pulley is dismantled, the pulley mover is used to prevent the
bearing from being strongly impacted by the load.
◆
To ensure safety, protective covers or similar devices, such as pulleys
installed on shaft, are installed in the rotating area.
Centering
◆
When installing the servo motor, make it conform to the centering accuracy
requirement shown in the picture below. If the centering is inadequate, vibration
will occur, and sometimes the bearing and encoder may be damaged. When
installing the coupling, please do not directly impact the motor shaft, otherwise
the encoder installed on the opposite side of the load shaft will be damaged.
Installation
direction
◆
Servo motor can be installed in horizontal or vertical direction.
Oil and water
solutions
When using in places where water droplets are dropping, please use it on the
basis of confirming the protection level of servo motor. (except for the
shaft-through part) When oil droplets will drip into the shaft-through part,
please specify the servo motor with oil seal.
Conditions for use of servo motors with oil seals:
◆
Make sure the oil level is below the lip of the oil seal when using.
◆
Please use the oil seal to keep the splash of oil droplets in good condition.
◆
When the servo motor is installed vertically upward, please pay attention not
to oil accumulation on the lip of the oil seal.
Stress state of cable
◆
Do not "bend" or apply "tension" to the wire, especially the core of the
signal line is 0.2mm or 0.3mm, very thin, so when wiring (using), do not make
it too tight.
Processing of
Connector Part
For the connector part, please pay attention to the following items:
◆
When connecting the connector, please make sure that there is no foreign
matter such as garbage or metal sheets in the connector.
◆
When connecting the connector to the servo motor, it is necessary to connect
the connector from the side of the main circuit cable of the servo motor first, and
the grounding wire of the main cable must be connected reliably. If one side of
The maximum and minimum deviations are
less than 0.03mm (rotated with the coupling)
measured at four locations in a circle.
The maximum and minimum deviations are less than 0.03mm
(rotated with the coupling) measured at four locations in a circle.
