12
ML628 IBERT Getting Started Guide
UG806 (v1.0) May 20, 2011
Running the GTH IBERT Demonstration
•
Parallel Cable IV (PC4)
Connect the ribbon cable between the programming cable and the ML628 board at
JTAG connector J1.
4.
Select the GTH IBERT demonstration with the System Ace™ controller CFG
ADDRESS switch, SW3. The setting on this 3-bit DIP switch (
) selects the file
used to configure the FPGA. A switch is in the ON position if it switched towards the
ON text printed on the DIP; otherwise, it is OFF. For the Quad 117 GTH IBERT
demonstration, set: ADR2 = ON, ADR1 = OFF, and ADR0 = OFF.
There is one IBERT demonstration design for each GTH and GTX Quad on the ML628
board, for a total of 16 designs. The designs are organized and stored on the two CF
cards (
IBERT #1
and
IBERT #2
) as shown in
.
5.
Place the main power switch SW1 to the ON position.
X-Ref Target - Figure 1-8
Figure 1-8:
Configuration Address DIP Switch (SW3)
Table 1-1:
CF Card Contents and Configuration Addresses
CF Card
Demonstration
Design
ADR2
ADR1
ADR0
IBERT #1
GTH Quad 106
OFF
OFF
OFF
GTH Quad 107
OFF
OFF
ON
GTH Quad 108
OFF
ON
OFF
GTH Quad 116
OFF
ON
ON
GTH Quad 117
ON
OFF
OFF
GTH Quad 118
ON
OFF
ON
GTX Quad 100
ON
ON
OFF
GTX Quad 101
ON
ON
ON
IBERT #2
GTX Quad 102
OFF
OFF
OFF
GTX Quad 103
OFF
OFF
ON
GTX Quad 104
OFF
ON
OFF
GTX Quad 105
OFF
ON
ON
GTX Quad 112
ON
OFF
OFF
GTX Quad 113
ON
OFF
ON
GTX Quad 114
ON
ON
OFF
GTX Quad 115
ON
ON
ON
UG
8
06_c1_0
8
_022511
CFG
ADDRESS
ADR0
ADR1
ADR2
S
W
3
ADR0 = OFF
ADR2 = O
N
12
3
O
N
ADR1 = OFF
