Page 6-14
Xerox WorkCentre PE120i System Administration Guide
Ne
twor
k
Ins
ta
lla
tio
n
Us
in
g In
ter
n
e
t Se
rv
ic
e
s
TCP/IP
Use these instructions to install the device on a TCP/IP network using CentreWare Internet
Services.
Installation Procedure
There are two stages required to install the device on a TCP/IP network using CentreWare
Internet Services:
¾
Configure the
WorkCentre PE120i
This procedure explains how to use CentreWare Internet Services to
configure the device.
¾
Test Print
A print job should be submitted to ensure the device has been installed and
configured correctly.
Configure the WorkCentre PE120i
NOTE:
The TCP/IP settings for the device will have been setup when completing
the
Enabling CentreWare Internet
Services section.
To complete the installation of the device, perform these steps:
¾
Enable CentreWare Internet Services (see
“Enabling Internet Services” on page 6-5
).
¾
At the CentreWare Internet Services Home Page for the
WorkCentre PE120i
, select the
[Properties]
tab.
¾
Select the plus symbol
[+]
to the left of the
Connectivity
folder in the
Properties
frame,
and then select the
[+]
symbol to the left of the
Protocols
folder.
¾
Select
[TCP/IP]
and check the
Protocol Configuration
details are correct. If any of the
details are incorrect then enter the correct information.
¾
In the
Physical Connection
field, Ethernet will be the default setting.
Select the checkbox to enable TCP/IP.
Enter the
[Host Name]
.
Choose the
[IP Address Resolution]
required.
1
2
3
4
5