Xerox VersaLink B615, User Manual

Page: 206 / 220

Pan-European Analog PSTN and
Compatible PBX Certifications
Spain Lithuania Finland
Sweden Luxembourg France
United Kingdom Malta Germany
If you have problems with your product, contact your local Xerox representative. This product can be
configured to be compatible with other country networks. Before reconnecting the device to a network
in another country, contact your Xerox representative for assistance.
Note
• Although this product can use either loop disconnect (pulse) or DTMF tone signaling, Xerox
recommends that you use DTMF signaling. DTMF signaling provides reliable and faster call setup.
• Modification of this product, or connection to external control software or control apparatus not
authorized by Xerox, invalidates its certification.
New Zealand
1. The grant of a Telepermit for any item of terminal equipment indicates only that Telecom has
accepted that the item complies with minimum conditions for connection to its network. It indicates
no endorsement of the product by Telecom, it does not provide any sort of warranty, and it does
not imply that any Telepermitted product is compatible with all Telecom network services. Above
all, it provides no assurance that any item will work correctly in all respects with another item of
Telepermitted equipment of a different make or model.
The equipment may not be capable of correct operation at the higher data speeds designated.
33.6kbps and 56kbps connections are likely to be restricted to lower bit rates when connected to
some PSTN implementations. Telecom will accept no responsibility for difficulties that arise in such
circumstances.
2. Immediately disconnect this equipment should it become physically damaged, then arrange for its
disposal or repair.
3. This modem shall not be used in any manner which could constitute a nuisance to other Telecom
customers.
4. This device is equipped with pulse dialing, while the Telecom standard is DTMF tone dialing. There
is no guarantee that Telecom lines will always continue to support pulse dialing.
5. Use of pulse dialing, when this equipment is connected to the same line as other equipment, may
give rise to 'bell tinkle' or noise and cause a false answer condition. If you encounter such problems,
do not contact the Telecom Faults Service.
6. DTMF tones dialing is the preferred method because it is faster than pulse (decadic) dialing and is
readily available on almost all New Zealand telephone exchanges.
Warning
No '111' or other calls can be made from this device during a mains power failure.
7. This equipment may not provide for the effective hand-over of a call to another device connected
to the same line.
Xerox ® VersaLink ® B605/B615 Multifunction Printer B-12
User Guide
Regulatory Information