Xerox N2125N - DocuPrint B/W Laser Printer, Service Manual

Page: 170 / 335

02/2000
4-71 DocuPrint N2125
REP 10.8, REP 10.9
Repair-Adjustment Initial Issue
REP 10.8 Motor Drive Assembly
Parts List on PL 14.2
Removal
WARNING
Switch off the power and disconnect the Power Cord.
1. Remove the Offset Catch Tray ( REP 10.1 ).
2. Remove the Exit Tray Extension ( REP 10.2 ).
3. Remove the Exit Tray ( REP 10.3 ).
4. Turn the Offset Catch Tray upside down.
5. Remove the Lower Cover ( REP 10.5 ).
6. Hold open the Rear Cover.
7. Remove the Inner Exit Chute Assembly ( REP 10.6 ).
8. Remove the two screws that secure the motor to the Inner Exit Chute Assembly ( Figure
1 ).
9. Disconnect P/J210 from the Offset Catch Tray PWB and remove the motor ( Figure 1 ).
Figure 1 Motor Drive Assembly
Replacement
1. Install the motor with both tabs touching the plastic standoffs.
2. The ground wire on top and the earth plate at the bottom should be on the outside ( Figure
1 ).
3. Reinstall the components in the reverse order.
REP 10.9 Static Eliminator
Parts List on PL 14.2
Removal
WARNING
Switch off the power and disconnect the Power Cord.
1. Remove the Offset Catch Tray ( REP 10.1 ).
2. Remove the Exit Tray Extension ( REP 10.2 ).
3. Remove the Exit Tray ( REP 10.3 ).
4. Turn the Offset Catch Tray upside down.
5. Remove the Lower Cover ( REP 10.5 ).
6. Hold open the Rear Cover.
7. Remove the Inner Exit Chute Assembly ( REP 10.6 ).
8. Remove the three screws that secure the Static Eliminator to the Inner Exit Chute ( Figure
1 ).
9. Remove the Static Eliminator ( Figure 1 ).
Figure 1 Static Eliminator
Replacement
1. Reinstall the components in the reverse order.
manuals4you.com manuals4you.com