Xerox document centre285 series, User Manual

Page: 118 / 209

5.2 Mode Menu Items
106
Mode
M
e
nu and Common Menu
5
Symbol Set
(con’t...)
Proper selection of Symbol Set is important in printing the required output.
Font Size Sets the height of the font in points.
The range of setting is between 4 to 50. Default is 12 and each unit is 0.25.
●
The point size item available depends on the fonts source and font number selected.
●
The values set are changeable by commands.
● The setting takes on default value when the NVM is initialized.
●
This item is ignored in the selection of a fixed-space scalable font. It is saved and is
available when a bitmap font or a proportionately-spaced scalable font is selected.
Font Pitch Sets the pitch of the font in character per inch.
The range of setting is between 6 to 24. Default is 10.00 and each unit is 0.01.
Pitch is the horizontal spacing of a fixed-space (bitmap or scalable) font in terms of
number of characters per inch.
This characteristic is ignored when selecting a proportionately-spaced (bitmap or
scalable) font but is saved in the font select table and available when fixed spaced font is
selected.
Form Lines Sets the page length (printing area) of one page.
The range of setting is between 5-128 lines with 1 line per unit. Default is 64.
● The values set are changeable by commands.
●
The setting takes on default value when the NVM is initialized.
No. of Sets Sets the number of output copy.
The range of setting is between 1-999 copies. Default is 1 and each unit is 1.
●
When there is a specific number of output from the host device, this value can be
displayed and printed out. Also, it can be changed on the setting of the operator panel.
However, number of specified output from Netware, lpd and AppleTalk cannot be
changed to the operator panel.
●
If there is instruction from the host device regarding the number of output copy, that
value will be reflected and printed. After printing, the setting of the control panel will be
overwritten by that value.
●
However, for number of output copy specified by Netware, lpd, AppleTalk port, the value
of the control panel will not be overwritten after printing.
Image Enhance Enables or disables image enhancement. Image enhancement is to raise the
resolution and to produce smooth print of sharp edges.
The candidate values are:
• On (default)
•
Off
●
The values set are changeable by commands.
●
The setting takes on default value when the NVM is initialized.
Menu item Explanation