Xerox 4595, System Administration Manual

Page: 94 / 402

Xerox 4595 Copier/Printer System Administration Guide 5-4
5. Using the Scan Service
NOTE 1: Enter address in the format “xxx.xxx.xxx.xxx”
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: Specify the subnet mask by a combination of the
numbers 0, 128, 192, 224, 248, 252, and 255. However,
you cannot use 0 between non-zero values.
NOTE 3: If you do not wish to set the gateway address,
enter “0.0.0.0.”
4.
Select
Close
repeatedly until the
System Settings
screen is
displayed.
5.
Select
Exit
.
6. After the machine is restarted, print out the Printer Settings
List to confirm that the mail send port is enabled and TCP/IP is
configured.
Configuring the E-mail environment
This section describes the configuration procedure to use the
scanner (mail transmission) function.
NOTE 1: The configuration can also be performed using
CentreWare Internet Services.
NOTE 2: Enable the SOAP port and the SNMP port in most cases.
Refer to “Using CentreWare Internet Services” on page 3-1.
1.
Display the
System Administrator Menu
screen.
a. Press the
Log In/Out
button.
b. Enter the UserID using the numeric keypad and then
select
Confirm
.
NOTE: The default User ID value is 11111. When using the
Authentication feature, a password is required. The default
password is x-admin.
c. Select
System Settings
.