Xerox 4595, System Administration Manual

Page: 108 / 402

Xerox 4595 Copier/Printer System Administration Guide 5-18
5. Using the Scan Service
5.
Set the IP address.
If the IP address is already set, this step is not necessary.
Also, in an environment with DHCP or BOOTP, configure the
way to obtain the address. If the address cannot be obtained
automatically or manual configuration is preferred, configure
the IP address, subnet mask, and gateway address.
a. Select
Close
repeatedly until the
Network Settings
screen is displayed.
b. Select
Protocol Settings
.
c. Select
TCP/IP - Get IP Address
and then select
Change
Settings
.
d. Select one from
DHCP
,
BOOTP
,
RARP
,
DHCP/Autonet
or
Manual
. If you select anything other than
Manual
, proceed
to step 6.
NOTE: When using a DHCP server, also configure the
WINS (Windows Internet Name Service) server.
e. Select
TCP/IP - Get IP Address
and then select
Change
Settings
.
f. Enter the IP address using the numeric keypad.
NOTE 1: Enter address in the format “xxx.xxx.xxx.xxx”
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: When you make an entry mistake, press the C
(Clear) button and enter again.
NOTE 3: When you would like to move to the next value
without entering all 3 digits, select Save/Select Next.
g. Select
Save
.
h. Configure
TCP/IP - Subnet Mask
and
TCP/IP - Gateway
Address
as shown above.
NOTE 1: Enter address in the format “xxx.xxx.xxx.xxx”
where xxx should be a numeric value in the range from 0
to 255. However, 224 or 225.xxx.xxx.xxx and
127.xxx.xxx.xxx cannot be used.
NOTE 2: Specify the subnet mask by a combination of the
numbers 0, 128, 192, 224, 248, 252, and 255. However,
you cannot use 0 between non-zero values.
NOTE 3: If you do not wish to set the gateway address,
enter “0.0.0.0.”