Xerox 4595, System Administration Manual

Page: 114 / 402

Xerox 4595 Copier/Printer System Administration Guide 5-24
5. Using the Scan Service
Configuration of the Job Flow
This section describes the configuration procedure to use the job
flow scan function on the machine.
The following is the procedure to use the job flow scan function:
•
Enabling the port and setting TCP/IP
Enable the SOAP port, SNMP port, and Internet service port,
and set IP addresses on the machine.
• Configuring the SNMP port
Configure the transport protocol for the SNMP port using
CentreWare Internet Services.
• Configuring the computer
Enabling the ports and setting the IP addresses
In order to use the job flow service, enable the SOAP port, SNMP
port, and Internet service port, and set IP addresses. The
procedure for setting the machine follows.
NOTE: The configuration can also be performed using
CentreWare Internet Services.
Refer to“Using CentreWare Internet Services” on page 3-1.
1.
Display the
System Administrator Menu
screen.
a. Press the
Log In/Out
button.
b. Enter the UserID using the numeric keypad and then
select
Confirm
.
NOTE: The default User ID value is 11111. When using the
Authentication feature, a password is required. The default
password is x-admin.
c. Select
System Settings
.
2.
Enable the SOAP port.
a. Select
System Settings
.
b. Select
Network Settings
.
c. Select
Port Settings
.
d. Select
SOAP
and then select
Change Settings
.
e. Select
SOAP - Port
and select
Change Settings
.
f. Select
Enable
and then select
Save
.
g. Select
Close
.