Xerox 2135N - Phaser Color Laser Printer, Quick Reference Manual

Page: 34 / 199

Service Guide 21
EE Transfer Belt Missing, Reseat Belt EE-Transfer Belt Unit
Missing
1. Remove and re-install the transfer belt unit.
2. Clean the transfer belt unit’s contact on the front-left side of the engine
chassis. Clean the corresponding contacts on the transfer belt unit.
3. Install a new transfer belt unit.
4. Replace the engine controller board.
5. Replace the printer unit chassis.
EF Fuser Missing, Reseat Fuser EF-Fuser Unit Missing
1. Remove and reinstall the fuser.
2. install a new fuser.
3. Replace the low-voltage power supply.
4. Replace the engine controller board.
H1 Disk Read Error, Press Enter to Clear
A hard disk error was detected that prevented
data from being read from the disk. H1-Disk Read Error
H2 Disk Write Error, Press Enter to Clear
A hard disk error was detected that prevented
data from being written to the disk. H2-Disk Write Error
H3 Disk Full Error, Press Enter to Clear
A hard disk full error occurred that prevented
data from being written to the disk H3-Hard Disk Full
1. Turn the printer off and on again.
2. Ensure the hard drive is properly installed.
3. Re initialize the hard drive. by scrolling to the Reset Menu and selecting
the submenu item Disk Init .
4. Replace the hard drive.
5. Replace the system controller board.
J3 Replace Fuser J3-Replace Fuser
1. Install a new fuser.
2. If a new fuser has been installed but the print engine continues to ask for a
new fuser, reset the fuser life count using the topic “Consumable count
initialization” on page 73.
3. Replace the engine controller board.
J4 Replace Transfer Belt J4-Replace Transfer Belt
1. Install a new transfer belt.
2. If a new transfer belt has been installed but the print engine continues to
ask for a new transfer belt, reset the transfer belt life count using the topic
“Consumable count initialization” on page 73.
3. Replace the engine controller board.
Printer fault messages
Code Front panel message Service message