Xerox 1235/DX - Phaser Color Laser Printer, Advanced Features And Troubleshooting Manual

Page: 108 / 144

92 Phaser 1235 Network Color Printers
Troubleshooting
EE-Transfer Belt Unit
Missing
Fault The transfer belt is either missing or requires
reseating to be recognized by the printer. Turn off
the printer, make sure the transfer belt is properly
installed and turn on the printer. If the problem
persists, check the support links at
www.xerox.com/officeprinting/1235support
.
EF-Fuser Unit Missing
Fault The fuser is either missing or requires reseating to
be recognized by the printer. Turn off the printer,
make sure the fuser is properly installed and turn
on the printer. If the problem persists, install a
new fuser. For further assistance, visit the support
links at
www.xerox.com/officeprinting/1235support .
H1-Hard Disk Read Error
Attention There was a hard disk read error that prevented
the data from being read. Press the
Enter
button to
clear the message. Turn off the printer, wait 15
seconds, then turn on the printer. If the problem
persists, visit the support links at
www.xerox.com/officeprinting/1235support
for
further assistance.
H2-Hard Disk Write Error
Attention There was a hard disk write error that prevented
the data from being written. Press the Enter button
to clear the message. Turn off the printer, wait 15
seconds, then turn on the printer. If the problem
persists, visit the support links at
www.xerox.com/officeprinting/1235support for
further assistance.
H3-Hard Disk Full
Attention There was a hard disk full error that prevented the
data from being written. Press the
Enter
button to
clear the message. Print or delete Secure Print and
Proof Print jobs to free up disk space.
H4-Hard Disk Formatting
Attention The hard disk is being formatted. Data cannot be
written to the disk until the formatting is
completed.
H5-Hard Disk Initializing
Attention The hard disk is being initialized. Data cannot be
written to the disk until the formatting is
completed.
J3-Replace Fuser
Fault The fuser has reached its end of life. Install a new
fuser.
J4-Replace Transfer Belt
Fault The transfer belt has reached its end of life. Install
a new transfer belt.
J n -Replace Drum
[J5-Replace Yellow Drum]
[J6-Replace Magenta
Drum]
[J7-Replace Cyan Drum]
[J8-Replace Black Drum]
Fault The imaging drum has reached its end of life.
Install a new imaging drum.
Printer Management Status Messages (cont'd.)
Message Type Explanation/Corrective Action