Xantrex Freedom SW 230V 815-3524-02, Owner'S Manual, Page: 74 / 104

60 Freedom SW 230V Owner’s Guide
Configuring the Freedom SW using the SCP
Setting the Device Number
Setting the device number gives a Xanbus-enabled device a unique
identity when several devices of the same type are installed in the
power system network. When each identical device has a unique
number, the Xanbus SCP can correctly identify and display status
information for each device. A device number consists of two digits
ranging from 00 (default) to 31.
If only one of each type of device is installed in the network, you do
not need to set the device number. However, setting the device
number to a value other than 00 is recommended in case you need to
use the
Restore Defaults
command (which resets the device
number to 00). After performing the command, checking that the
device number has returned to 00 indicates that the command was
successfully completed.
To set the Freedom SW 230V device number:
1. On the Freedom SW 230V Setup menu, select
Advanced Settings
.
If
Basic Settings
appears instead of
Advanced Settings
on the
Setup
menu, display
Advanced Settings
by pressing
Enter + Up arrow + Down arrow simultaneously.
On the
Advanced Settings
menu, select
Stacking
and press
Enter .
2. On the
Stacking
menu, select
Dev Number
.
3. Press Enter to highlight the instance number.
4. Use the up and down arrow buttons to adjust the two-digit
identifier number.
5. Press Enter .
Figure 34 Setting a Device Number
FSW3524E 00: Stacking
[ FSW3524E ]
[01]
[Master]
Dev Name
Dev Number
Stack Mode
FSW3524E 00: Stacking
Dev Name
Dev Number
Stack Mode [ FSW3524E ]
[*01]
[Master]
FSW3524E 00: Stacking
[ FSW3524E ]
[01]
[Master]
Dev Name
Dev Number
Stack Mode
3
5
4
Steps 1 and 2 are not
shown.
FSW 230V Owners Guide.book Page 60 Tuesday, August 7, 2018 9:38 AM