SmartPad LCD
Page:
13
© 2003 Xantech Corporation
Section 2: Installation & Connections
INSTALLATION
BACK BOX MOUNTING INSTRUCTIONS
All four models of the SPLCD Touch Panel are to be mounted into its corresponding junction box (included). No
screws are necessary for affixing this junction box into drywall, lath & plaster, button board or other surfaces
covering a hollow wall. This wall needs to be at least 3.5” (8.9cm) deep.
A Mounting Template Wall-Cutout is included for precise hole dimensions. There are three models, one for
each display size (3.9”, 5.7” and 6.4”).
NOTE:
The mounting hole size is critical as there is a +0.00” inch tolerance for this cutout. It is imperative that
the provided mounting template be used to assure proper hole size. Check the table below to be sure you are
using the proper Mounting Wall-Cutout Template.
SPLCD Model # Mounting Template Part No.
SPLCD39G 08187158
SPLCD57G 08187156
SPLCD64G 08187157
SPLCD64V 08187157
CUT OUT
CUT OUT
CUT
OUT
CUT
OUT
Figure 4 – Back Box Mounting Wall-Cutout Template
Please follow the instructions that follow closely:
1. Place the mounting template on the wall as shown in
Figure 4
above.
2. Make sure the Template is level and gently secure to the wall using a hammer
3. Using a hole saw or other cutting tool, carefully cut along the inner guide lines of the Mounting
Template as shown in
Figure 5
below.
