14
Smart Pad
3
CLR MEM
RESTORE
NETWORK
PGM
TRNS
XFER
ERR
CNCL
FULL
DEL
EDIT
DELAY
SEQ
IR
STEP
C
O
M
B A 9 8 7 6
5
4
3
2
1
0
F
E
D
C
PROTECT
WRITE
NETWORK
ADDRESS
Programming
Buttons
Source (Bank)
Buttons
Function
Buttons
Function
Buttons
Fig. 16
Programming, Source &
Function Buttons
NOTE:
The LM110 includes only a
NETWORK
LED and a
RESTORE
button. Refer to illustration on
page 6.
17. WRITE PROTECT
Switch. Must be in
WRITE
position for all programming.
PROTECT
position
prohibits programming and protects all stored data from unintended erasure.
18. NETWORK ADDRESS
- 16 position (0~F) switch allows up to 16 PM110/LM110 modules to have a
unique network address. Each module on a common IR bus (network) must be set to a unique network
address, prior to programming, to allow network cloning.
PROGRAMMING
Power Up:
Begin by connecting the keypad to a typical system such as that shown in
Fig 3
. Be sure the
STATUS terminal is connected to +12V so that the source (bank) LEDs will light. Also, set the
WRITE/
PROTECT
switch to
WRITE
and the
NETWORK ADDRESS
to a
unique position
for each keypad used
in the system.
The following conditions are established when power is applied:
• The unit resets and operation begins.
• The keypad defaults to bank #1 (top left source button) after each power up.
• The unit is now ready for programming, communications with a PC or cloning of programmed contents
from one keypad to another.
Learning IR Command Codes
To teach IR commands to the unit, refer to
Figs. 15
&
16
and proceed as follows:
1. Press the desired
Source
(bank) button. The
Source button LED will light.
2. Press the
PGM
(program) button. The PGM
LED will flash.
CAUTION:
Use a blunt tool when pressing the
programming buttons, such as the tip of a 3.5mm
mini plug. Do not use pens, pencils, etc., as they
may damage or contaminate the switch mate-
rial.
3. Now press the desired target key (one of the
Function
or
Source
buttons).
With the target button selected and the PGM
LED has stopped flashing, you are ready to input
the IR command from the handheld remote
control.
NOTE:
If you change your mind and wish to
teach a different button than the one you just
selected, simply press CNCL once, and press
the other button.
4. With the remote pointed at the IR window (1 to 2 inches away),
press the key on the remote
that has
the command you want to save.
The PGM & SEQ LED's will flash while storing. When storing is complete, the PGM LED will flash again
by itself.
NOTE:
If the ERR (error) LED flashes, an error has occurred during programming (such as holding
the handheld remote too far away from the keypad, for example), indicating the unit has not learned
