13
Controllers
Smart Pad
3
Button & LED Indicator Descriptions
The following small buttons and indicators are located on the PM110 in the space between the two gangs
and under the right key module as shown on page 6 and
Fig 15
.
NOTE
: Use a blunt tool to press
programming buttons, such as the tip of a 3.5mm mini plug.
Do not use sharp objects!
Fig. 15
Programming Buttons & Indicators
PGM
TRNS
XFER
ERR
CNCL
FULL
DEL
EDIT
DELAY
SEQ
IR
STEP
CLR MEM
RESTORE
NETWORK
1
2
3
4
5
6
7
9
8
10
11
13
14
15
16
C
O
M
12
17
B A 9 8 7 6
5
4
3
2
1
0
F
E
D
C
PROTECT
NETWORK
ADDRESS
18
WRITE
for the controlled equipment. The TRNS (transmit) LED will light whether or not there is continuity in
the output circuit. It will not light with bank tracking codes coming from other keypads.
9. DEL
- Deletes single, sequenced & tiered IR commands from any individual key.
DEL LED flashes when in Delete Mode.
10. XFER
- This key, with a subsequent press of the PGM key, initiates the transfer (cloning) of
programmed contents from one keypad to another via the
COM
Port connector. Also, pressing XFER
then SEQ, will initiate cloning to multiple keypads via the
IR OUT
(Network) line.
11. ERR
or LED - Lights when an IR command cannot be learned correctly during the learning process.
12. IR
- This Infrared sensor window receives IR commands from remote controls for programming only.
It
will not
repeat commands through the network system.
13. COM
Port - RS232 signal compatible port for uploading or downloading to/from a computer or
transferring programmed contents from one keypad to another.
14. CLR MEM
- Clear Memory. Erases all user programmed commands when pressed twice within 1
second. Bank key flashes momentarily. Also
restores all factory defaults
for Speaker Relay, Code
Group and Bank Tracking Programming.
15. RESTORE
- Resets unit to restart operation after errors, lockups, etc. Program key flashes
momentarily. Does not erase user programmed commands.
16. NETWORK
LED - Flashes with any activity on the IR output line (IR commands being transmitted, bank
tracking codes, etc.).
1. PGM
- Places the keypad in Program Mode.
PGM LED flashes when in Program Mode.
2. CNCL
- Cancels (exits) the various program-
ming modes. LED's will stop flashing.
3. FULL
LED - Flashes when the user program
memory is full.
4. SEQ
- Places keypad in Sequence mode for
programming of command sequences (or mac-
ros).
SEQ LED flashes when in Sequence Program-
ming mode.
5. DELAY
- Adds timed delays (1 to 30 seconds)
between commands in a Sequence, either dur-
ing first programming of a Sequence or subse-
quent Editing of a Sequence.
DELAY LED flashes when in Delay Mode.
6. EDIT
- Allows editing of existing sequences.
EDIT LED flashes when EDIT is first pressed.
7. STEP
- Steps through each command when
editing a Sequence (in EDIT mode).
8. TRNS
LED - Lights steady during the interval
when IR commands are sent to the IR output line
