ECRESO FM 100/300 W, user manual– 06/2015
Page 27
Head Office : Parc d’activites Kennedy - 20, avenue Neil Armstrong – 33700 Bordeaux-Merignac (France)
Tel +33 (0)5 57 928 928 – Fax +33 (0)5 57 928 929 –
www.worldcastsystems.com – [email protected]
4.2.5.
Setting the analog or AES inputs
G O
T O
-> L I N E 1 >
1
L I N E 1
-> L E V E L : + 0 6 . 0 0
1
G O
T O
M A I N
-> L I N E 1
Press the “+” key until you see the Line1 (or Line2) menu. Then
press the “Enter” key.
Browse through the Line1 (or Line2) menu using the “+” and “–
” keys to set the nominal level between -50 and +50 dBu.
Use the “Enter” key to switch to edit mode, the “+” and “–” keys
to adjust values and the “Enter” key to confirm.
Press the “+” key until you see this screen. When the Line1 (or
Line2) menu is selected, press “Enter” to return to the list of
menus.
Default transmitter pre-accentuation is 50 µs. Depending on your country, you might need to switch it to 75 µs (in the
United States for instance). The Pre-accentuation parameter is only visible in Expert mode; you must therefore first
change the front panel working mode:
9 8
.
0 0 M H z
1 0 0 W
-> E A S Y
G O
T O
-> L I N E 1 >
1
L I N E 1
-> P R E A C : 5 0
1
G O
T O
-> M A I N
-> L I N E 1
Press the “+” key until you see the Easy menu. Then press the
“Enter” key, “+” and “Enter” again to switch to Expert mode.
Go back to the Line1 menu. Press the "Enter" key then the “+”
key to change the pre-accentuation.
Use the “Enter” key to switch to edit mode, the “+” and “–” keys
to adjust values and the “Enter” key to confirm.
Press the “+” key until you see this screen. When the Line1 (or
Line2) menu is selected, press “Enter” to return to the list of
menus.
4.2.6.
Getting on air
1.
Disable the RF using the front panel RF button.
2.
Make sure the RF indicator LED is off.
3.
Disconnect the load and connect the antenna to the transmitter RF output.
4.
Enable the RF again using the front panel RF button.
