ECRESO FM 100/300 W, user manual– 06/2015
Page 51
Head Office : Parc d’activites Kennedy - 20, avenue Neil Armstrong – 33700 Bordeaux-Merignac (France)
Tel +33 (0)5 57 928 928 – Fax +33 (0)5 57 928 929 –
www.worldcastsystems.com – [email protected]
6.
FRONT SCREEN USE
6.1.
Overview
The transmitter can be entirely set using the front panel application.
For audio configuration you will use the following menus:
Input Switch
: to select the main audio source and the secondary audio sources and to set switching criteria
between these sources.
Line1 / Line2 / MPX1 / MPX2 / Player / Audio Gene
: to set levels and processes for each source.
Modulation
: to set the deviation for each sub-carrier of the multiplex signal. In this menu you may also
enable RDS and SCA.
Stereo Encoder
: to choose the content of stereo sub-carrier of the multiplex signal.
RDS/SCA Encoder
: to choose the content of the RDS and SCA sub-carrier of the multiplex signal.
RDS
: to set the RDS.
The default mode for the transmitter is the “Easy” mode: only menus required for basic configuration are available.
For instance, the RDS menu mentioned above is not visible.
To display all menus, simply switch to “Expert” mode:
9 8
.
0 0 M H z
1 0 0 W
-> E A S Y
From the main screen, press the “Enter” key to display the
menu and press the “+” key until you see the Easy menu. Then
press the “Enter” key, “+” and “Enter” again to switch to Expert
mode.
On the menu representations in the following pages:
“Easy” menus are in green
“Expert” menus are in orange
On startup, the screen displays the name of the unit, its software release and its serial number.
6.2.
Working principle
!
Press the Local button on the front panel: the transmitter must be in local mode before parameters can be
modified.
Three keys allow you to browse through the menus:
With the
and
keys, go from one screen to the next or rather from one command to the next: if 2 commands
are available on a single screen, press
twice to go to the next screen.
A command is selected when an arrow is visible before its name.
ENTER
1
S T
E N C O D E R
-> M O / S T : S T E R E O
1
S T
E N C O D E R
A U D I O
C H :
L I N E 2
