Manual 04121
ProAct I/II
Woodward
51
2.
Logged Errors provides a means of recording errors that the control detects.
The error log will be saved, even if power to the control is lost. To clear the
error log, press the “hot” (“black square”) key.
3.
Self Test Result displays the result of power up diagnostics performed on
the microprocessor, data, and program memory. A successful test gives a
result of 49. Contact Woodward if the self test result is not 49.
Conclusion of Test and Calibration Procedures
This completes the calibration instructions. Save the set points by pressing the
SAVE key on the Hand Held Programmer. Power down the control for about 10
seconds. Restore power and verify that all set points are as recorded.
To prevent possible damage to the engine resulting from improper
control settings, make sure you save the set points before removing
power from the control. Failure to save the set points before
removing power from the control causes them to revert to the
previously saved settings.
Disconnect the Set Point Programmer from the control.
Be prepared to make an emergency shutdown when starting the
engine, turbine, or other type of prime mover, to protect against
runaway or overspeed with possible personal injury, loss of life, or
property damage.
Summary of Contents for ProAct I
