Woodward ProAct I, Product Manual

Page: 37 / 67

Manual 04121 ProAct I/II
Woodward 35
Menu 4—Limiter Settings
Menu Low Default High
Item Value Value Value Units
Max Fuel Limit 0 100 100 %
Transient Over Fuel 0 0 100 %
Transient Time 0 0 10 seconds
Start Fuel Limit 0 40 100 %
Start Ramp Rate 0 1 20 %/second
Start Speed 0 400 1200 rpm
Min Torque Limit 0 50 100 %
Torque Limit BP 0 1500 2100 rpm
Torque Limit at BP 0 70 100 %
Max Torque Limit 0 90 100 %
Menu 5—Monitor Menu
Speed rpm
Speed Reference
rpm
Actuator Output %
Aux Input volts
Remote Input mA
Run/Stop Switch Open/Closed
Idle Rated Switch Open/Closed
Raise Switch Open/Closed
Lower Switch Open/Closed
Alternate Dynamics Switch Open/Closed
Remote Reference Switch Open/Closed
Isoch Switch Open/Closed
Diagnostic Switch Open/Closed
Speed Switch A On/Off
Speed Switch B On/Off
Speed Switch C On/Off
Fault Lamp On/Off
Menu 6—Configuration Set Points
Menu Low Default High
Item Value Value Value Units
*Configuration Key 0 0 100 NA*
Number of Gear Teeth 4 60 500 NA
Dynamics Map Linear Linear Nonlinear NA
Failsafe Function Disabled Enabled Enabled NA
*—Must be set at "49" before any changes can be made. Engine must be at 0 rpm
and the Run/Stop at OPEN to make any changes in this menu.
The Failsafe Function must be enabled during normal engine
operation to prevent possible overspeed should the MPU signal be
lost for any reason. As soon as the control senses engine speed, the
failsafe becomes enabled. The function can be overridden to allow
some slow cranking engines to start, and to test parts of the
governor system without running the engine. Failure to enable the
Failsafe Function could allow overspeed with resulting damage to
equipment and possible personal injury or death.