-32-
Model W1805 (For Machines Mfd. Since 7/15)
SE
RV
IC
E
If the belt is left loose, it can stop during operation while
the pulley continues to spin. This scenario will burn the
belt, which will create a horrible vibration and smell of
burned rubber. If this ever happens, then the belt must
be replaced before continuing operations.
Tools.Needed.
Qty
Hex Wrench 6mm ...............................................1
To.replace.the.belt,.do.these.steps:
1.
DISCONNECT MACHINE FROM POWER!
2.
Lower the cutter as far as it will go.
3.
Remove the dust plug shown in
Figure.50
to access
the top of the belt.
4.
Loosen the two motor mount cap screws shown in
Figure.48
.
5.
Turn the motor tension bolt, shown in
Figure.49
,
counterclockwise to loosen the belt.
6.
Slide the belt over the top of the spindle shaft and
off of the motor pulley.
7.
Reinstall and tension the new belt.
8.
Replace the dust plug, and tighten the motor mount
cap screws.
Belt.Replacement
Tools.Needed.
Qty
Hex Wrench 6mm ...............................................1
To.tighten.the.belt,.do.these.steps:
1.
DISCONNECT MACHINE FROM POWER!
2.
Loosen the two motor mount cap screws shown in
Figure.48
.
3.
Turn the belt tension bolt, shown in
Figure.49
,
clockwise to tension the belt.
.
Note:
Each time you adjust the belt tension,
only
turn the bolt one full turn. This will prevent over-
tightening the belt, which can lead to premature
bearing failure in the motor and spindle.
Figure.48.
Motor mount cap screw
locations.
Figure.50.
Dust plug removed to see top
of cutter spindle for belt removal.
Figure.49.
Belt tension bolt.
Motor Mount
Cap Screws
Belt Tension
Bolt
Dust Plug
Access Hole
Summary of Contents for Shop Fox W1805
Page 48: ......
