Installation and Setup
Exhaust Module Installation
3
3-17
WMDKdoc020322
Installation and Setup
3.8
Exhaust Module Installation
Drill a hole (
102mm) for the exhaust fan through the wall of the kiln. Mount the
sliding exhaust valve to the outside chamber wall. To do that, position the valve on
the chamber wall, mark and drill the mounting holes. Drill only through the outer skin
of the kiln using a 11 mm drill bit. Next, install the rivet nuts (the squeeze size on the
riveter indicator should be set at 1 mm). Position the valve once more and check if
the Exhaust Vent Hole Liner length fit the chamber wall thickness (the hole liner
should not protrude from the hole in the chamber wall. If the hole liner is too long cut
it to the proper length. Apply a silicone sealant to the hole liner and insert into the
hole from the outside of the kiln.
FIG. 3-16
∅
Exhaust Vent Hole Liner
Silicone sealant
WDK011
