Rev AB
Printing Faults 8-5
Wolke m600 touch Operator Manual
The optical fiber is not inserted
deeply enough.
Insert the optical fiber into the relevant
holes as far as the stop and secure with
the lever.
The cartridge is empty.
Replace the cartridge with a new one.
The protective tape on the
nozzle rows on the cartridge
was not removed.
The nozzle rows on new cartridges are
protected by a protective tape. If you
forget to remove this protective tape the
cartridge will not be ready for printing.
Please check whether the protective
tape has been removed.
If the printer is not used for a
while it is possible that one or
more of the nozzles can dry out
(the open time is dependent on
the type of ink, the ambient
temperature and the air
humidity).
Remove the cartridge and clean the
nozzles. It is recommended that you
use a microfiber cloth to clean them. For
optimum cleaning results, dampen the
cloth slightly with distilled water.
The cartridge was not inserted
correctly.
Remove the cartridge from the
printhead and insert it correctly.
The contacts on the cartridge
may be soiled.
Please clean the contacts with a dry
microfiber cloth.
Printing is triggered by an
external sensor. This has been
correctly connected to the I/O
port at the back of the Wolke
m600 touch but has not been
correctly parameterized in the
External inputs
menu of the
Wolke m600 touch.
Please check the settings in the
External inputs
menu of the Wolke
m600 touch. The settings for the sensor
in the system settings may not match
those for the settings in the
External
inputs
menu.
Fault
Cause
Solution
Table 8-1: Printing Faults (Continued)
