Rev AB
Reverse Print 6-27
Wolke m600 touch Operator Manual
a. If you have selected
Disable,
then the message
Production Disabled
appears.
b. If you have selected
No Print,
then the message
Non Printing Job
appears.
Reverse Print
Reverse printing is used in systems where printheads are moved on
traveling units. Reverse printing permits printing in both directions of
movement. This chapter provides information on setting the following:
• Input
• Installation
• Job
Input Settings
In case of reverse printing, an input is configured to be used to control the
printing direction. Refer to the Wolke m600 touch Service Manual for
more information.
In the preferred direction, the printing direction is determined by setting
in the installation settings. If printing is required contrary to the preferred
printing direction, this input must be assigned a
high
level. This changes
over the printing direction prior to the print trigger signal. This
Figure 6-33: Line Select Page
