Check the next figure for the pinout and check the 12V DC voltage on the microfit connector (by a
multimeter) of the power adapter that it provides 12V or not. If not, than remove the 12V DC
adapter and get another one with the proper pinout and voltage.
Connecting to the router, checking connection
Set the IP address of the
Ethernet interface
on the PC where it can be reached (in the Microsoft
Windows
®
:
Control panel / Network / Network Adapter / Adapter settings)
. Ping the router
IP address.
If you can connect, you can ping an IP address out of the OpenWrt interface to check network
access on the mobile Internet.
Ethernet connection
Check or connect the RJ45 UTP6a type cable to the
ETHERNET
port. When the router is operating,
the
Ethernet
port LEDs must sign the network activities.
If you do not have an Ethernet cable
connection, you can use a micro USB connection for the bridge connection to access the router's
web interface.
When you cannot access router through SSH or on its web interface
Download
the micro-USB cable
driver and install it
before using the cable from the M2M
http://www.wmsystems.hu/m2m-downloads/USB_Ethernet_RNDIS_DRIVER.zip
Unzip the downloaded zip file to a directory and install it.
Establish a USB connection between the PC and the router with a micro-USB cable connected to the
socket marked
USB
. (The driver must be installed on the PC according to the
Installation Guide
).
Set the IP address of the
USB-Ethernet interface
on the PC for the “
USB Ethernet / RNDIS
Gadget
” network connection (
Control Panel / Network / Network Adapter / Adapter
Settings
). You can also voltage the device on the
USB
connection at the IP address.
