Wittenstein cyber motor cyber dynamic 17, Operating Manual

Page: 23 / 30

cyber
®
dynamic line Maintenance and disposal
Revision: 04 5022-D029179 en-21
7.1 Maintenance
日本語
español
françai
s
italiano
english
deutsch
7 Maintenance and disposal

Read the general safety instructions before beginning work (see Chapter 2.7 "General safety
instructions").
7.1 Maintenance
7.1.1 Cleaning
Clean the motor with a grease-dissolving, non-aggressive detergent.
7.1.2 Checking the holding brake
The motor can be optionally equipped with a holding brake.
To ensure the permanent functioning of the holding brake, it has to be regularly applied and
checked.
- It is recommended that the holding brake is released and applied at least twice daily by
deactivating the controller.
- It is recommended that the holding torque M
4
of the brake is checked at least once a day.

Details can be found in chapter 6.2 "Holding brake".
7.1.3 Visual inspection
Perform a monthly visual inspection:

Check the motor and moving cables for damage.

Check whether the cable ends are completely labeled.
7.2 Start-up after maintenance work

Attach all safety devices.
7.3 Information on the lubricant used
7.4 Disposal

Dispose of the motor at the recycling sites intended for this purpose.

Observe the applicable national regulations concerning disposal.
A change of lubricant in motors of this design is not necessary. All motor
bearings, gearheads and threaded spindles are permanently lubricated at
the factory.