Wittenstein cyber motor cyber dynamic 17, Operating Manual

Page: 17 / 30

cyber
®
dynamic line Assembly
Revision: 04 5022-D029179 en-15
5.2 Attaching motor to a machine
日本語
español
françai
s
italiano
english
deutsch
5.2 Attaching motor to a machine
5.3 Components mounted to the output side
Please contact our Sales department for additional information. Always enter the serial number
(SN, current designation) or the product identification number (PIN, previous designation).

Observe the safety and processing instructions for the threadlocker to be
used.

Installation examples for reaching specific IP protection classes 10
"Appendix II".

Coat the fastening screws with a threadlocker.

Fasten the motor to the machine with the
fastening screws through the threaded holes
(A).

Mount the motor in such a way that the
identification plate remains legible.

Only use washers for motors that have an
aluminum flange.

For specified tightening torques for screws
of property class A2-70, see section 9.1
"Tightening torques for common thread
sizes in general mechanical engineering",
Table "Tbl-8".
Fastening screws that are screwed in too far can damage the motor.

Screw in the screws only up to their maximum depth.

See dimensional drawing (5007–...)
Tensions during the assembly may damage the motor.

Assemble the gears and the toothed belt pulleys without force on the
output shaft.

Never attempt to assemble by force or hammering!

Only use suitable tools and devices for assembly.
A
A