Winmate R10IBWS-MHP1, User Manual

Page: 68 / 79

M-Series HMI Mounting Solutions
User Manual
68
6 Mounting Solutions
This chapter provides mounting guide for all available mounting options. Pay attention
to cautions and warning to avoid any damages.
CAUTION/ ATTENTION
Follow mounting instructions and use recommended mounting hardware to
avoid the risk of injury.
Suivez les instructions de montage et d'utilisation recommandé le matériel
de montage pour éviter le risque de blessure.
6.1 Cable Mounting Considerations
For a nice look and safe installation, make sure cables are neatly hidden behind the
HMI device. Refer to
Chapter 2, section 2.1 for the cable installation instruction.
CAUTION/ ATTENTION
Observe all local installation requirements for connection cable type and
protection level.
Suivre tous les règlements locaux d’installations, de câblage et niveaux de
protection.
CAUTION/ ATTENTION
Turn off the device and disconnect other peripherals before installation.
Éteindre l’appareil et débrancher tous les périphériques avant
l’installation.
6.2 Safety Precautions
Observe the following common safety precautions before installing any electronic
device:
• Use separate, non-intersecting paths to route power and networking wires. If
power wiring and device wiring paths must be crossed make sure the wires are
perpendicular at the intersection point.
ALTERNATING CURRENT / MISE À LE TERRE!
To prevent electrical shock, the Safety Ground location on the rear must
be bonded to the local earth ground through a minimum 12 AWG wire as
short as possible
Pour éviter les chocs électriques, l’emplacement de la prise terre à
l’arrière doit être lié à terre locale, à travers un 12 AWG minimum et
aussi court que possible.