Winmate R10IBWS-MHP1, User Manual

Page: 25 / 79

M-Series HMI Getting Started
User Manual
25
Note:
A pair of needle nose pliers may be helpful when working with jumpers. If
you have any doubts about the best hardware configuration for your
application, contact your local distributor or sales representative before
you make any changes. Generally, you simply need a standard cable to
make most connections.
The jumper setting diagram is shown below. When the jumper cap is placed on both pins,
the jumper is SHORT. The illustration below shows a 3-pin jumper; pins 1 and 2 are short.
If you remove the jumper cap, the jumper is OPEN.
Both Jumper 8 and Jumper 9 allow setting the Serial Port COM1 configuration. Refer to
the table below for PIN assignment.
The picture below shows RS-232/422/485 (J8/J9) jumper setting.
Example:
To make RS-232 Settings, set the Jumper 8 Pin 1-2 to the SHORT position, and
Jumper 9 Pin1-2, 4-5, 7-8, 10-11 to the SHORT position.
RS-232 RS-422 RS-485
JP8 1-2 3-4 5-6
JP9 1-2
4-5
7-8
10-11
2-3
5-6
8-9
11-12
2-3
5-6
8-9
11-12