Wilson Electronics MAXX 2 Series, Owner'S Manual

Page: 44 / 83

6. Refer to the Alignment Table (see
Section 9) and locate the correspon-
ding ear height. This will indicate the
location of the rear alignment spike on
the Alignment Block. The standard
spike is installed at the factory and
requires no installation - do not
remove it. Choose the proper spike
(standard or 2 inch). If the 2-inch
spike is required for your setup, screw
it into the threaded hole on the center
44
M A X X S
E R I E S
2 O
W N E R
’
S
M
A N U A L
F
I G U R E
1 2 - A
L I G N M E N T
B
L O C K S T E P
C O N F I G U R AT I O N
F
I G U R E
1 3 - A
L I G N M E N T A S S E M B LY W I T H S TA N D A R D S P I K E
A
L I G N M E N T
S
T E P O N E
A
L I G N M E N T
S
T E P F I F T E E N