Wilson Electronics MAXX 2 Series, Owner'S Manual

Page: 66 / 83

66
M A X X S
E R I E S
2 O
W N E R
’
S
M
A N U A L
Amplifier shuts off as soon as it is turned
on:
If the problem is solved:
If the problem persists:
crossover cover. You will find some resistor
connections. These are labeled “Front
Tweeter Level”, “Midrange Level”, “Midrange
Phase”, and “Woofer Damping.” Replace the
resistor with the supplied matching resistor.
Tighten the new resistor in the old one’s place.
Note: Use only Wilson Audio replacement
resistors in your MAXX. These resistors
were carefully chosen for the overall sonic
and thermal performance.
Plug your amplifier into the wall and turn it
on.
Listen to the channel at a low level. The driver
should now be operating correctly.
Check to see if your speaker cables are proper-
ly secured. Look for frayed ends, loose con-
nections, or a conductor contacting the ampli-
fier chassis.
Turn the amplifier off and disconnect it from
the AC wall outlet. Disconnect the preamplifi-
er leads to the amplifier. Now turn on the
amplifier.
There is likely something wrong with your pre-
amplifier or interconnect. Contact your deal-
er.
Leave the preamp leads disconnected and con-
tinue to the next step.