Wilson Electronics MAXX 2 Series, Owner'S Manual

Page: 26 / 83

the casters on the woofer are toward the floor.
3. While one person holds the crate, the other person should roll the woofer enclo-
sure out of the crate. Be very careful
not to scratch the module
during this process.
4. Finally, move the woofer
cabinets over to the “Zone
of Neutrality” as deter-
mined by the Wilson Audio
setup procedure. If you
have not yet performed this
room analysis, please refer
to Section 1.0 of this manu-
al.
Reminder: Place the odd serial
numbered woofer on the LEFT and
the even numbered module on the
RIGHT.
5. Remove the empty woofer
crates from the room.
U n c r a t i n g t h e U p p e r A r r a y M o d u l e s
1. Locate the crate labeled “Upper Modules.” Both
Upper Modules are packed in this single crate.
Remove the left and right upper modules from the
crate (see Figure 4). It is very important to ensure
that each of the modules are matched to correspon-
ding Woofer Module by serial number. The serial
tags are located on the rear of each. Be very careful
26
M A X X S
E R I E S
2 O
W N E R
’
S
M
A N U A L
F
I G U R E
3 - W
O O F E R
M
O D U L E
F
I G U R E
4 - U
P P E R
M
O D U L E