Wilson Electronics MAXX 2 Series, Owner'S Manual, Page: 65 / 83

65
S
E C T I O N
7 - T
R O U B L E S H O O T I N G
One channel is not operating...
Imaging is off-center...
A chronic lack of bass energy...
Driver out or not playing after connec-
tions have been verified.
Check the interconnects from source.
Check the connections on the speaker cables, both
at the amplifier and speaker ends. Watch espe-
cially for connectors touching each other.
Check the Upper Range Signal Cables. You may
have forgotten to connect them, or they may have
shorted or come loose during setup.
Check your connections. A connection to one of
the modules may have come loose. When a tweet-
er or midrange driver is not working, or is out of
phase, the MAXX will not “image” properly.
Double check your connections for red-to-red and
black-to-black.
Play music at a low level and listen to each driver
in each channel. You may have a driver that is
not operating correctly. If you find a driver that
is silent, please go to the “Driver Out” section of
this troubleshooting guide.
Check the input cable connections on your woofer
enclosure. If one channel is out of phase (connec-
tions reversed), bass will be cancelled. Note:
Turn off your amplifier, and unplug it from the
wall.
If you have found a driver with no output, move
to the rear of this particular loudspeaker.
Using the appropriate Allen key, open the lower
aluminum door on the back of the upper