Installation Manual: Whipple SC 21_F150_R5
Last Updated: June 12
th
, 2021
Page 31 of 39
www.whipplesuperchargers.com
82.
(Stage 2 Whipple 132mm Crusher throttle body) Install throttle body to supercharger inlet, use the supplied
gasket between TB adapter and SC inlet. Secure with the supplied (3) 6mm x 25mm SHCS and (1) 6mm x 50mm
SHCS using a 5mm allen socket. Torque to 85 lbs-in.
83.
Connect the electronic throttle extension to the electric motor. Press until it clicks and locks into place. Press the
safety lock until it clicks and locks into place. NOTE:
Secure harness with zip-tie. It should have some slack
around connector for motor vibration, only zip-tie to avoid belt system.
84.
Lightly bend the (2) ground wire so it goes below the frame. NOTE: Failure to do so will rub airbox and push airbox
towards firewall and cause fitment issues.
85.
Install the supplied lower airbox into factory (2) hole locations. Using the supplied (2) 1.1” L x .30” W plastic push
pins, secure front of snorkel to factory location.
