WHILL F, User Manual

Page: 15 / 120

14
WHILL Model F User Manual
1
Table 5 - Signal input/output parts Port
Phenomenon Basic EMC standard Immunity test levels
Home healthcare environment
Conducted disturbances
induced by RF fields IEC 61000-4-6 3 V, 0.15 MHz-80 MHz
6 V in ISM bands and amateur radio bands
between 0.15 MHz and 80 MHz
80% AM at 1 kHz
1.1.3. FCC and ISED information
The controller on the WHILL Model F contains the following wireless communication modules that are regulated
by the FCC (Federal Communications Commission) and the ISED (Innovation, Science and Economic Development
Canada).
• Model No: MDBT42Q-P192K
FCC ID: SH6MDBT42Q
IC: 8017A-MDBT42Q
The controller is labelled with an FCC ID and an ISED certification number. The label is accessible without the use
of tool by removing the controller as shown in Section “Switching the position of the controller”.
FCC Information
This device complies with part 15 subpart B and C of the FCC rules. Operation is subject to the following two
conditions.
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CAUTION:
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to
operate this equipment.
This device meets the government’s requirements for exposure to radio waves. This device is designed and
manufactured not to exceed the emission limits for exposure to radio frequency (RF) energy set by the Federal
Communications Commission of the U.S. Government.