SVA Cover Set 1•5
7
Steering Wheel Cover
NOTE:
The steering wheel requires a cover that is
deformable for SVA.
1
Locate the steering wheel cover [R] from
your parts
2
Push the cover over the wheel locating
the three lugs into the wheel (Fig 6.1).
7.1
8
Head Lamp Covers
NOTE:
Some SVA centers do not have a problem
with the headlamp brackets although some
have failed the brackets. To counter this
problem there are two GRP covers supplied
in your set.
1
Locate one of the covers they are sided
L/H & R/H.
2
Place the cover at the back of the
bracket and cable tie to the steel
headlamp bracket (Fig 8.1).
8.1
9
Head Lamp Raiser
NOTE:
The head Lamps require lifting slightly for
SVA, two spacers are supplied in the kit to
do this.
1
Locate the two spacers [D] from your
parts.
2
Remove the headlamps from the car.
3
Refit the head lamp with the spacer
positioned on the threaded section of
the mounting point (Fig 9.1).
9.1
4
Secure with the original nut.
5
Repeat the process for the other lamp.
10
Bonnet Catch Covers
NOTE:
Two covers are required for the bonnet
catches if you are not running locks. The
covers are similar to the ones used for the A
pillar but they are larger.
1
Locate from your parts the two plastic
covers [H] from your parts.
2
Press the covers over the latches
11
Damper Covers
NOTE:
Two covers are supplied to cover the height
adjustment ring on the damper [A]. The
covers require the center cutting out to fit
them. They are only required on the front
dampers.
1
Cut the center from the cover. Also put
a slit in the edge so that it can be fitted
without removing the damper.
2
Wrap the cover round the damper and
cable tie in position.
3
Repeat the process for the other
damper.
